Resetting The Brocade Fcoe Switch Module To Factory Defaults - IBM Brocade FCoE Installation And User Manual

Resetting the Brocade FCoE Switch Module to factory defaults

ATTENTION
Restoring the switch module to factory defaults is disruptive. Before beginning, make sure that any
program using the high speed switch module has an alternate path to the storage and save the
switch module configuration. If the high speed switch module is connected to an existing SAN,
disconnect the switch module from the SAN before restoring to factory defaults and then follow
proper setup procedures before reconnecting.
Use the Management Module to reset the high speed switch module to factory defaults.
1. Open the Management Module and log in with admin privileges.
2. Select I/O Module Tasks > Configuration.
3. Select either bay 7 or bay 9 depending on where the switch module is installed.
4. Select Advanced Configuration.
5. Click Restore Defaults.
34
Brocade FCoE Switch Module for IBM BladeCenter: Installation and User Guide