Opening The 3105 Attendant Console Label Cover; Moving Your Telephone; Swapping Telephones - 3Com VCX Manual

Opening the 3105 Attendant Console Label Cover

Moving Your Telephone

Swapping Telephones

For instructions on how to create and print labels, see Printing Labels.
Figure 9 3105 Attendant Console Label Cover Tabs
Each VCX telephones is uniquely identified by an IP address. You can move your
telephone to another location within your calling domain, connect it to any Ethernet jack
on the LAN, and still maintain all of your personalized features, speed dials, and
extension number.
Your administrator assigns a password for your telephone. This password associates
your telephone extension (and mailbox) with your account. This may allow you to
configure another VCX telephone in the system to duplicate your primary phone. This
means if you are away from your primary telephone (for example, in a different office),
you can program the local telephone to use your extension. Any calls made to your
extension will ring in both locations and you can access your mailbox from either phone.
See the overview section in the chapter that describes your telephone for more
information.
After you print the labels
and then cut them out,
remove the plastic cover
from the Attendant
Console by pulling up on
the two tabs at the top of
the Attendant Console
until the top of the cover
pops off.