Activating Do Not Disturb - 3Com VCX Manual

incoming call, the ringer is muted.

Activating Do Not Disturb

next to the Do Not Disturb button.
from the display panel and the red light goes out.
All non-ringer tones are unaffected. All ring tones, such as, internal domain, external
domain, and anonymous tones are affected for all primary, bridge, and hunt-group calls.
A user with a telephone on hands-free hears the hands-free tone. A user that receives a
page hears the page tone.
If the VCX system or the telephone reboots or is upgraded with new software, the ringer
resets to the default ringer enabled (feature disabled) mode.
To mute the telephone ringer:
1) Press Feature + 489. The LCD displays:
Ringer is now muted.
2) To clear the display, press the Release button. The next time you receive an
3) To turn this feature off, press Feature + 489 again. The LCD displays:
Ringer is now enabled.
4) To clear the display, press the Release button.
When you enable Do Not Disturb, incoming calls immediately go to the call coverage
point set by you or your administrator. The default call coverage point is your voice
mailbox. The call coverage point is set through the VCX User Interface (see Chapter7).
When your telephone is in Do Not Disturb mode:
An incoming call does not cause your telephone to ring. If you are logged in to
multiple telephones using the same telephone number and one of the telephones
enables Do Not Disturb, the feature applies to all telephones—an incoming call will
not ring on any of the telephones.
You can use the telephone to dial outgoing calls.
If you enable Do Not Disturb while one or more calls are ringing, the pending calls
are sent to your call coverage point and Do Not Disturb is enabled for all subsequent
calls.
If you are a Hunt Group member and you enable Do Not Disturb, personal
(non-Hunt Group) calls go to your call coverage point. However, Hunt Group calls
always ring on a member's telephone, regardless of the Do Not Disturb setting.
If your telephone is part of a bridged extension, see Do Not Disturb and Bridged Line
Calls for additional information.
To activate Do Not Disturb:
1) Press the Do Not Disturb Access button on the telephone. The red light is lit
Your telephone is now in Do Not Disturb mode. The display panel shows Do Not
Disturb.
2) To disable Do Not Disturb mode, repeat step 1. The DND message disappears