Table of Contents
Advertisement
IPC6521-Z20-FI 1080P Intelligent Network Speed
Dome
User Guide
Step 5 Run the ./help debug close module ID command to disable the debug log.
For example: ./help debug close 1
----End
Configuring Media Streams
Step 1 Run the cd /usr/app/bin/ command.
Step 2 Run the ./help setmediaopen command.
The command output is displayed:
Usage: help setmediaopen [VideoStreamType] [ProtocolType] [IPAddress] [Port]
[PacketType] [LocalEthNo]
Set Media Stream open.
VideoStreamType:
ProtocolType:
Port:need to input even numbers.
PacketType:The type of media packet.
LocalEthNo:
Without this parameter, the default use Wire Network card.
Step 3 Enter the media stream type, transmission protocol, IP address and port number for receiving
media streams, pocket type, and network port as prompted.
The port number must be an even number that ranges from 1001 to 65535; otherwise, the
command is invalid.
For example: ./help setmediaopen 0 0 192.168.0.200 10000 0 0.
Step 4 Run the ./help setmediaclose [SessionID] command.
The configured media streams can be disabled.
Issue 02 (2013-09-30)
The debug log is automatically disabled 10 minutes after the debug log is enabled.
0
Host Stream
1
Sub Stream One
2
Sub Stream Two
0
UDP
2
Multicast
0
ES stream packet
1
PS stream packet
0
Wire Network card
1
Wireless Network card
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
F Appendix help Command Reference
123
Advertisement
Table of Contents
