Appendix 3 Installing The Maintenance Printer Driver - Brother MFC-J3520 Service Manual

APPENDIX 3. INSTALLING THE MAINTENANCE PRINTER DRIVER
To identify machines connected via USB direct interface, the PC requires the
corresponding driver for the virtual USB device. If you connect any number of
machines to your PC, the same number of virtual USB devices will be automatically
configured on your PC. To prevent many virtual USB devices from being configured,
use the unique driver installation procedure described below that enables your PC to
identify terminals via one single virtual USB device.
NOTE: Once this installation procedure is carried out for a PC, no more driver/software
installation will be required for that PC to identify machines. If the Brother
Maintenance USB Printer driver has been already installed to your PC
according to this procedure, skip this section.
Windows 2000/Windows XP
(1) Check that the power switch of the machine is turned off. Disconnect the USB
cable that connects the machine with your PC.
(2) Turn ON your PC.
(3) Turn ON the power switch of the machine.
(4) Switch the machine to the maintenance mode. (Refer to
(5) Connect the machine to your PC using a USB cable.
The following window appears.
(6) The following screen appears, indicating the detection of new hardware device by
the system. Select "No, not this time." And click Next.
App. 3-1
Chapter 5.)
Confidential