Removing/Replacing Inner And Outer Rear Panels; Changing The Foam Rubber Seal - Asko T700 Series Service Manual

INNER AND OUTER REAR PANELS AND FOAM RUBBER SEAL
REMOVING THE INNER AND OUTER REMOVING THE INNER AND OUTER REMOVING THE INNER AND OUTER
REMOVING THE INNER AND OUTER REMOVING THE INNER AND OUTER
REAR P REAR P REAR P REAR P REAR PANELS ANELS ANELS ANELS ANELS
1. Remove the top cover (see page 23) and the rear
panel (see page 26).
2. Remove the screws and the cable clamp that
secure the inner rear panel to the outer panel.
3. Lift them apart. The bearing is now free and
can be removed.
Screws
P/N 8900338
Outer rear panel
P/N 8061829
REPLACING THE INNER AND OUTER REPLACING THE INNER AND OUTER REPLACING THE INNER AND OUTER
REPLACING THE INNER AND OUTER REPLACING THE INNER AND OUTER
REAR P REAR P ANELS ANELS
REAR P REAR P REAR PANELS ANELS ANELS
4. Put the inner rear panel on to the drum shaft
and feed it on to the bearing.
5. Align the outer rear panel and secure it with the
screws to the inner rear panel, along with the
cable clamp.
WARNING WARNING
WARNING WARNING WARNING
It is important that the wiring bundle runs along
its groove.
26
Inner rear panel
P/N 8061851
6. Secure the rear panel to the side panels and
bottom.
7. Install the remaining wiring in accordance with
the electrical schematic diagram.
8. Replace the top cover. Don't forget the two star
washers for the outer screws.
9. Tighten the centering nut.

CHANGING THE FOAM RUBBER SEAL

CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL
1. Remove the cover (see page 23) and the rear panel
(see page 26).
2. Remove the screws that secure the rear panel sides
and bottom.
3. Remove the screws that secure the inner and
outer rear panels.
4. Lift off the outer rear panel.
5. Change the foam rubber seal.
6. Put the outer rear panel in place.
7. Secure the rear panels to each other.
8. Secure the rear panels to the machine.
9. Replace the top cover. Don't forget the two star
washers for the outer screws.
Foam rubber seal
P/N 8003576