Asko T700 Series Service Manual page 28

HEATING ELEMENT AND OVERHEAT PROTECTION THERMOSTAT
CHANGING THE HEATING ELEMENT CHANGING THE HEA CHANGING THE HEA CHANGING THE HEA CHANGING THE HEA
1. Remove the top cover (see page 23).
2. Remove the rear panel (see page 26).
3. Remove screws that secure the inner and outer
rear panels, along with the cable clamp.
4. Lift off the outer rear panel.
5. Unscrew the heating element.
6. Install a new heating element or clean the old
one.
7. Secure the heating element.
8. Put the outer rear panel in place.
9. Secure the rear panels to each other.
10. Secure the rear panels to the machine.
11. Replace the top cover. Don't forget the two star
washers for the outer screws.
Heating element
P/N 8063808
28
TING ELEMENT TING ELEMENT TING ELEMENT TING ELEMENT CHANGING THE OVERHEA CHANGING THE OVERHEA CHANGING THE OVERHEAT T T T T CHANGING THE OVERHEA CHANGING THE OVERHEA
PRO PRO TECTION THERMOST TECTION THERMOST TECTION THERMOSTA A A A A T T T T T
PRO PROTECTION THERMOST PRO TECTION THERMOST
1. Remove the top cover (see page 23).
2. Remove the rear panel (see page 26).
3. Remove the screws that secure the inner and
outer rear panels, along with the cable clamp.
4. Lift off the outer rear panel.
5. Unscrew the overheat protection thermostat.
6. Fit the new overheat protection thermostat.
7. Secure the thermostat.
8. Put the outer rear panel in place.
9. Secure the rear panels to each other.
10. Secure the rear panels to the machine.
11. Replace the top cover. Don't forget the two star
washers for the outer screws.
Overheat protection device
P/N 8008487