Side Panels - Asko T7OO Series Service Manual

https://appliancetechmanuals.com

SIDE PANELS

CH AN G I N G TH E SI D E P CH AN G I N G TH E SI D E P
CH AN G I N G TH E SI D E PAN ELS CH AN G I N G TH E SI D E P CH AN G I N G TH E SI D E P
1. Remove the front panel (see page 25).
2. Remove the control panel (see page 43).
3. Early models: the hole is marked out on the
bottom.
Early models: the hole is marked out on the
front rail.
4. Using a narrow chisel, cut off the rivet heads
(7) and break those on the front rail off with a
screwdriver (2).
5. Lift away the side panel.
6. File or grind smooth the places where the rivets
were in the bottom and use a polygrip to flatten
the front rail.
W ARN I N G W ARN I N G W ARN I N G
W ARN I N G W ARN I N G
The edges of the bottom and the front rail where
the rivets were placed must be completely flat and
smooth.
7. Early models: Drill a 1/ 2" diameter hole in the
bottom at the marking.
Early models: Drill a 3/ 16" diameter hole in
the front rail at the marking.
8. Install three clips at the bottom of the side
panels.
9. Screw the side plates to the bottom from
underneath and to the front rail.
10. Replace the front panel.
11. Replace the control panel.
AN ELS AN ELS
AN ELS AN ELS
Side panels
P/N 8801174-0 (wh, no holes)
P/N 8801174-95 (ss, no holes)
P/N 8801175-0 (wh, w/hole, left)
P/N 8801176-0 (wh, w/hole, right)
P/N 8801175-95 (ss, w/hole, left)
PN 8801176-95 (ss, w/hole, right)
51