Asko T700 Series Service Manual page 42

CONTROL P P P P P ANEL
REMOVING THE CONTROL P REMOVING THE CONTROL P
REMOVING THE CONTROL PANEL REMOVING THE CONTROL P REMOVING THE CONTROL P
1. Remove the top cover (see page 23).
2. T700/720: Turn the knob to its zero position
and remove it from the panel. If you use a
polygrip (mole wrench), remember to put some
soft material in the jaws so as not to scratch the
plastic.
3. T720/780: Pull out the water tank.
4. T720/780: Unscrew the two screws that secure
the panel to the front rail.
T700/760: Unscrew the two screws securing the
front rail.
5. Remove the four snap fasteners at the bottom
edge by bending the clips apart with a 1/2" wide-
blade screwdriver. Take care when bending the
clips apart not to damage the plastic snap
fasteners in the panel.
6. Unhook the panel.
Control panels
P/N (see below)
Control Panel Part Numbers:
T700: P/N 8063456-0-UL
T720: P/N 8063457-0-UL
T760: P/N 8063458-0-UL (wh)
P/N 8063458-69-UL (blk)
T780: P/N 8063459-0-UL (wh)
P/N 8063459-69-UL (blk)
42
ANEL ANEL
ANEL ANEL
REPLACING THE CONTROL P REPLACING THE CONTROL PANEL REPLACING THE CONTROL P
REPLACING THE CONTROL P REPLACING THE CONTROL P
7. T700/720: Guide the panel over the
8. Hook on the top edge of the panel and snap
10. Replace the removed parts. Don't forget the two
CHANGING THE KNOBS (T700/T720) CHANGING THE KNOBS (T700/T720)
CHANGING THE KNOBS (T700/T720) CHANGING THE KNOBS (T700/T720) CHANGING THE KNOBS (T700/T720)
1. Turn the knob to its zero position and remove
2. Fit the new knobs.
CHANGING THE PROGRAMMING CHANGING THE PROGRAMMING
CHANGING THE PROGRAMMING CHANGING THE PROGRAMMING CHANGING THE PROGRAMMING
BUTTONS (T700/T720) BUTTONS (T700/T720) BUTTONS (T700/T720)
BUTTONS (T700/T720) BUTTONS (T700/T720)
1. Remove the control panel.
2. Change the buttons. (The buttons sit free on
3. Replace the control panel.
programming buttons.
closed the four snap fasteners at the bottom edge.
Support the center with a screwdriver as the
panel is pressed into place.
star washers for the outer screws when installing
the top cover.
it from the panel. If you use a polygrip (mole
wrench), remember to put some soft material
in the jaws so as not to scratch the plastic.
Knobs
P/N 8061892-0
the pushbutton switches.)
Programming buttons
P/N 8061711-0
ANEL ANEL ANEL
ANEL