Electronic Control Unit - Asko T700 Series Service Manual

ELECTRONIC CONTROL UNIT

CHANGING THE ELECTRONIC CHANGING THE ELECTRONIC
CHANGING THE ELECTRONIC CHANGING THE ELECTRONIC CHANGING THE ELECTRONIC
CONTROL UNIT (ECU) CONTROL UNIT (ECU) CONTROL UNIT (ECU)
CONTROL UNIT (ECU) CONTROL UNIT (ECU)
WARNING WARNING WARNING WARNING WARNING
A grounded EMC wristband must be worn at all
times when working with electronic components
to prevent damaging them.
1. Remove the top cover (see page 23).
2. Remove the wiring from the integral cable
clamps in the electronic control unit holder.
3. Unclip the ECU from its holder.
ECU
P/N 8061856
4. Remove all the wiring.
5. Connect all the wiring to the new control unit.
WARNING WARNING
WARNING WARNING WARNING
Ensure that all wires and connection blocks are
connected correctly. Wires are marked with board
connections.
6. Snap the ECU into its holder.
7. Replace the top cover. Don't forget the two star
washers for the outer screws.
REMOVING THE ELECTRONIC REMOVING THE ELECTRONIC REMOVING THE ELECTRONIC REMOVING THE ELECTRONIC REMOVING THE ELECTRONIC
CONTROL UNIT WITH ITS HOLDER CONTROL UNIT WITH ITS HOLDER
CONTROL UNIT WITH ITS HOLDER CONTROL UNIT WITH ITS HOLDER CONTROL UNIT WITH ITS HOLDER
1. Remove the top cover (see page 23).
2. Remove the control panel (see page 43).
3. Press in the two snap fasteners.
4. Slide the assembly sideways and remove it.
5. Remove the wiring.
ECU
P/N 8061856
Holder
P/N 8061921
REPLACING ELECTRONIC CONTROL REPLACING ELECTRONIC CONTROL REPLACING ELECTRONIC CONTROL
REPLACING ELECTRONIC CONTROL REPLACING ELECTRONIC CONTROL
UNIT AND ITS HOLDER UNIT AND ITS HOLDER UNIT AND ITS HOLDER UNIT AND ITS HOLDER UNIT AND ITS HOLDER
6. Install the wiring in accordance with its labels.
7. Align the holder to the front rail. Fit the four
hooks into the square holes in the front rail.
8. Move the holder sideways so it snaps into place.
9. Replace the control panel.
10. Replace the top cover. Don't forget the two star
washers for the outer screws.
47