Removing The Door; Changing The Hinge Pin; Replacing The Door; Changing The Hinge Socket - Asko T700 Series Service Manual

DOOR

REMOVING THE DOOR

REMOVING THE DOOR REMOVING THE DOOR REMOVING THE DOOR REMOVING THE DOOR
NOTE
The front door must remain closed during the entire
removal procedure (The door magnet will hold it
in place.)
1. Remove the lower cover (see page 24).
2. Unscrew and remove the three screws that secure
the hinge fixture.
3. Lift down the front door.
Hinge
P/N 8061807-0

REPLACING THE DOOR

REPLACING THE DOOR
REPLACING THE DOOR REPLACING THE DOOR REPLACING THE DOOR
4. Align the front door against the hinge socket in
the panel.
5. Close the front door so that the door magnet
holds it in place.
6. Put the hinge pin into its socket.
7. Tighten the three screws that secure the hinge
fixture.
8. Replace the lower cover
38
Outer door
P/N 8061733-0 (wh)
P/N 8061733-95 (ss)
Screws
P/N 8901097

CHANGING THE HINGE PIN

CHANGING THE HINGE PIN CHANGING THE HINGE PIN
CHANGING THE HINGE PIN CHANGING THE HINGE PIN
1. Remove the front door (see this page).
2. Unscrew the hinge pin.
NOTE
The illustration shows the lower hinge fixture. The
hinge pin is installed in a similar manner in the
upper hinge fixture.
3. Install the hinge pin.
4. Install front door.

CHANGING THE HINGE SOCKET

CHANGING THE HINGE SOCKET CHANGING THE HINGE SOCKET CHANGING THE HINGE SOCKET CHANGING THE HINGE SOCKET
1. Remove the three screws that secure the lower
hinge and twisting it free, take off the front door.
2. Change the hinge socket.
3. Hang the front door back on with the aid of
the door magnet and secure the hinge.
Hinge
P/N 8061807
Hinge socket
P/N 8061865-0
Inner door
P/N 8061810