Asko T700 Series Service Manual page 5

CONDENSA CONDENSA CONDENSATION DRAIN CONNECTION CONDENSA CONDENSA TION DRAIN CONNECTION TION DRAIN CONNECTION TION DRAIN CONNECTION TION DRAIN CONNECTION
(T720/T780) (T720/T780)
(T720/T780) (T720/T780) (T720/T780)
If possible, you should install the dryer so the
condensed water will continuously flow into a drain
or sink. To do this, follow the instructions below:
1. Disconnect the short hose (1) from the blue
nipple. (It's okay to let the hose hang down.)
2. Connect the rubber hose supplied with the dryer
to the blue nipple (2).
3. Run the hose to a drain or sink, as illustrated.
Try to keep the hose as straight as possible.
NOTE
The drain hose must not be more than 40" (1016
mm) above the floor.
Back of dryer
CONNECTION T O A VENTILA CONNECTION T CONNECTION T
CONNECTION T CONNECTION T
DUCT (T700/T760) DUCT (T700/T760) DUCT (T700/T760) DUCT (T700/T760) DUCT (T700/T760)
1. Connect the exhaust hose to a ventilation
exhaust fitting or to a discharge through the wall.
2. Secure the hose joint to the outlet stub on the
machine.
3. Run the hose with as few bends and loops as
possible to the point of discharge. If necessary, it
can be extended to a maximum of 22 feet (6600
mm) of 4" (100 mm) diameter ridged hose.
Make any bends as gentle as possible. A maximum
of four 90° bends may be fitted in the hose. The
more bends and the longer the hose, the less air will
circulate through the machine, which will impede
drying performance. Subtract 4 feet (1200 mm) for
every 90° elbow.
40"
(1016 mm)
maximum
height
If more than 22 feet of hose is needed, the diameter
must be increased to 6" or 8" (152 mm or 203 mm).
If the hose is taken to a wall outlet, a ventilation grill
should be fitted to prevent reverse flow of cold air.
Fit the ventilation grill to the
outside or inside of the wall.
Make sure nothing is blocking the ventilation grill.
WARNING! WARNING!
WARNING! WARNING! WARNING!
This appliance should never be exhausted into a
chimney, a wall, a ceiling, or a concealed space of
a building. Only a metal ventilation grill should
be used.
INSTALLATION
O A VENTILATION O A VENTILA O A VENTILA
O A VENTILA
Subtract 4 feet
(1200 mm) for
every 90° elbow.
Ventilation grill
TION TION TION
TION
5