Rear Panel - Asko T700 Series Service Manual

REMOVING THE REAR P REMOVING THE REAR PANEL REMOVING THE REAR P
REMOVING THE REAR P REMOVING THE REAR P
1. Remove the top cover (see page 23).
2. Unscrew the centering nut until the face of the
nut is level with the end of the thread and knock
out the bearing.
3. Fit the special tool (part no. 88 011 54) by fitting
the tube end into one of the stamped out
keyholes in the front rail. Lift the rear edge of
the drum and press the drum edge onto the
roller.
4. Remove the ground connection (yellow/green
wire) from the input terminal block (see pages
8 and 9).
5. Take the cable bundle out of the cable clamp
and pull the header block off its terminal pins.
6. Remove the wiring:
T700/T720: R1 a, R1 b, R1 13, R1 14, R1 34
on the contactor.
T760/T780: Ra, Rb, R13, R14, R34 on the
contactor and F3 and F4 on the radio
interference filter.
7. T720/T780: Remove the hoses to the water
tank housing.
8. Remove the centering nut and the eight screws.
NOTE:
Do not remove or loosen the screws around the
heater housing or drum bearing.
9. T720/T780: Remove the three plastic screws
at the lower part of the rear panel.
10. Lift off the rear panel.
REPLACING THE REAR P REPLACING THE REAR P REPLACING THE REAR P REPLACING THE REAR PANEL REPLACING THE REAR P
11. Hook the rear panel onto the base.
12. Remove the special tool.
13. Screw on the centering nut and fit the eight
screws.
14. T720/780: Refit the hoses.
15. Fit the grounding connection and the wiring:
T700/720: R1 a, R1 b, R1 13, R1 14, R1 34
on the contactor.
T760/T780: Ra, Rb, R13, R14, R34 on the
contactor and F3 and F4 on the radio
interference filter.
ANEL ANEL ANEL
ANEL
ANEL ANEL ANEL ANEL
16. Push the header block onto its terminal pins
and place the cable bundle in the cable clamp.
17. Replace the top cover. Don't forget the two star
washers for the outer screws.
Special tool
P/N 8801154

Rear panel

P/N 8061829
REAR PANEL
Screws
P/N 8900369
25