Asko T700 Series Service Manual page 45

CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS
CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS CHANGING THE PUSHBUTTONS
(T760/T780) (T760/T780) (T760/T780)
(T760/T780) (T760/T780)
WARNING WARNING WARNING WARNING WARNING
A grounded EMC wristband must be worn at all
times when working with electronic components
to prevent damaging them.
1. Remove the top cover (see page 23).
2. Remove the control panel (see page 43).
3. Remove the PCU board (see page 45).
4. Lift out the button sheet with the pushbuttons.
5. Install the pushbuttons. Take care when
installing the pushbuttons to get them in the
correct locations.
6. Replace the PCU board.
7. Replace the control panel.
8. Replace the top cover. Don't forget the two star
washers for the outer screws.
Pushbuttons
P/N 8061864-0 (wh)
P/N 8061864-33 (blk)
PUSHBUTTONS (T760/T780) AND TIMER (T700/T720)
REMOVING THE TIMER (T700/T720) REMOVING THE TIMER (T700/T720) REMOVING THE TIMER (T700/T720)
REMOVING THE TIMER (T700/T720) REMOVING THE TIMER (T700/T720)
1. Remove the top cover (see page 23).
2. Turn the knob to its zero position and remove
it from the panel. If you use a polygrip (mole
wrench), remember to put some soft material
in the jaws so as not to scratch the plastic.
3. Insert a screwdriver into one of the holes and
press in the latch while slightly turning the timer.
Do the same with the other latch.
4. Slide the timer sideways and pull it out.
T700 Timer
P/N 8061839
T720 Timer
P/N 8061868
REPLACING THE TIMER REPLACING THE TIMER
REPLACING THE TIMER REPLACING THE TIMER REPLACING THE TIMER
5. Position the timer in the holes in the front and
main panels. (Fit the four hooks into the square
holes in the front rail.) When changing the timer,
ensure that the wires are connected correctly to
the flat pin terminals.
6. Slide the timer sideways so it snaps into place.
7. Refit the knob.
8. Replace the top cover. Don't forget the two star
washers for the outer screws.
45