Asko T700 Series Service Manual page 6

INSTALLATION
FREESTANDING INST FREEST FREEST ANDING INST ANDING INSTALLA ANDING INST
FREEST FREEST ANDING INST
The dryer can be placed next to the washing machine.
There should be at least 1/2" (12.5 mm) of space
between the washer and dryer.
It is essential that the machine is level and the
locknuts are tight to eliminate vibration.
When installing the dryer next to a wall, be sure to
leave at least 1/2" (12.5 mm) of space between the
unit and the wall. This allows for door swing of
dryer. Never push the washer flush against the wall
because it may damage the machine casing or the wall.
6
ALLATION ALLA ALLA TION TION TION
ALLA TION
When installing the
dryer next to a wall, be
sure to leave at least
1/2" of space between
the unit and the wall.
BUIL BUILT T T T T -IN INST BUIL -IN INSTALLA -IN INST -IN INST ALLA ALLATION (T700/T760) ALLA
BUIL BUIL -IN INST ALLA
Models T700 and T760 can be installed beneath a
cabinet or worktop with a minimum height of 34"
(864 mm). There must be a gap of about 1/4" (.64
mm) all around the machine, including between the
rear edge of the machine top panel and the back wall.
The opening width must be at least 24" (610 mm).
Space must also be available for the exhaust hose on
the left, right or rear of the machine. See the diagram
for hole sizes and positions. Note that the hole
measurements are to the center of the hole.
NOTE
Do not raise the dryer higher than 34-1/2".
All hole measurements are
to the center of the holes.
TION (T700/T760) TION (T700/T760) TION (T700/T760)
TION (T700/T760)