Asko T700 Series Service Manual page 44

CONTROL PANEL
CHANGING THE PUSHBUTTON CHANGING THE PUSHBUTTON
CHANGING THE PUSHBUTTON CHANGING THE PUSHBUTTON CHANGING THE PUSHBUTTON
SWITCHES (T760/T780) SWITCHES (T760/T780) SWITCHES (T760/T780)
SWITCHES (T760/T780) SWITCHES (T760/T780)
1. Remove the control panel (see page 43).
2. Grasp the switch inside the machine and pull it
as you bend the wings at the front of the switch
inward with a screwdriver.
IMPORTANT
Take care to connect the correct wire to the correct
terminal.
3. Press in the new pushbutton and check that the
wings open out.
4. Replace the control panel.
Main power button switch, cycle button switch,
and anti-crease button switch
P/N 8061875
Quick cool switch
P/N 8057941
Start button switch
P/N 8061877
44
CHANGING THE PROCESSOR CONTROL CHANGING THE PROCESSOR CONTROL
CHANGING THE PROCESSOR CONTROL CHANGING THE PROCESSOR CONTROL CHANGING THE PROCESSOR CONTROL
UNIT (PCU) BOARD (T760/780) UNIT (PCU) BOARD (T760/780) UNIT (PCU) BOARD (T760/780)
UNIT (PCU) BOARD (T760/780) UNIT (PCU) BOARD (T760/780)
WARNING WARNING WARNING
WARNING WARNING
A grounded EMC wristband must be worn at all
times when working with electronic components
to prevent damage to them.
1. Remove the top cover (see page 23).
2. Remove the control panel (see page 43).
3. Remove the PCU board from the snap fasteners
with the aid of a screwdriver.
4. Lift it out.
5. Install the new PCU board.
6. Replace the control panel.
7. Replace the top cover. Don't forget the two star
washers for the outer screws.
PCU Board
P/N 8063875
Note:
Be careful not to break the tabs that hold in the
display unit.