Asko T700 Series Service Manual page 9

Connecting a Four Connecting a Four
Connecting a Four Connecting a Four-wire P Connecting a Four
WARNING! WARNING!
WARNING! WARNING! WARNING!
Before starting this procedure, be sure the power
is turned off at the breaker/fuse box.
Power Supply Cord
You will need a four-wire power supply cord with
four No. 10 copper wires and a matching four-wire
receptacle of NEMA Type 14-30R, as illustrated
below. The fourth wire must be identified with a
green cover and the neutral conductor by a white
cover.
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Assemble 3/4" UL-listed strain relief into the
hole below the terminal block opening.
4. Remove center terminal block screw.
5. Remove ground
wire (green with
yellow stripes)
from external
ground connector
screw. Fasten under
center, silver-
colored terminal
block screw.
6. Connect ground
wire (green) of
cord to external
ground conductor
screw.
7. Connect neutral wire (white) of cord under
center screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
-wire P -wire P ower Cord ower Cord
-wire P -wire Power Cord ower Cord ower Cord
10. Replace terminal box cover on back of dryer.
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.
13. Turn on the main power switch on the dryer.
(The power indicator light should come on.)
INSTALLATION
9