Removing The Motor; Replacing The Motor - Asko T700 Series Service Manual

REMOVING THE MOTOR

REMOVING THE MOTOR
REMOVING THE MOTOR REMOVING THE MOTOR REMOVING THE MOTOR
1. Remove the drum (see page 30).
2. Remove the lower cover (see page 24).
3. Remove the front fan housing cover (see page
33).
4. Unscrew the front fan wheel.
5. T720/780: Remove the external fan housing
(see page 33).
6. Disconnect the wiring in the switch housing on
the motor, and the grounding wire.
7. Unscrew the four screws securing the motor to
the bottom plate. To gain access to the screws
the belt pulley can be lifted off.
8. Lift out the motor.
Motor
P/N 8061895
10 mm nut
Front fan wheel
P/N 8061899
MOTOR AND CAPACITOR

REPLACING THE MOTOR

REPLACING THE MOTOR
REPLACING THE MOTOR REPLACING THE MOTOR REPLACING THE MOTOR
9. Align the motor with the four holes and secure it.
10. Connect the wiring. Don't forget to replace the
belt pulley.
11. Install the fan wheel and the cover for the fan
housing.
12. Replace the lower cover.
13. T720/780: Replace the external fan housing.
14. Replace the drum.
CHANGING THE CAPACIT CHANGING THE CAP CHANGING THE CAP
CHANGING THE CAP CHANGING THE CAP
1. Remove the top cover (see page 23) and the rear
panel (see page 26).
2. T720/780: Remove the external fan housing
(see page 33).
3. Unscrew the capacitor.
4. Install a new capacitor and connect the wiring.
Ensure the wiring connections are correct.
5. T720/780: Replace the external fan housing.
6. Replace the rear panel.
7. Replace the top cover.
ACIT ACIT OR ACIT OR OR OR
ACIT OR
33