Changing The Front Rail - Asko T700 Series Service Manual

CHANGING THE BASE P CHANGING THE BASE P
CHANGING THE BASE PAN CHANGING THE BASE P CHANGING THE BASE P
1. Remove the condenser housing (see page 49).
2. Early models: the hole is marked out on the
base pan.
3. Cut off the rivets between the base pan and side
panels.
4. Install six clips along the bottom edge of the
side panels.
5. Early models: Drill a 1/2" diameter hole in the
base pan at the marking.
6. Screw the side plates to the base pan from
underneath.
7. Replace the condenser housing.
Base pan
P/N 8061618
52
AN AN
AN AN
BASE PAN AND FRONT RAIL

CHANGING THE FRONT RAIL

CHANGING THE FRONT RAIL CHANGING THE FRONT RAIL
CHANGING THE FRONT RAIL CHANGING THE FRONT RAIL
1. Remove the control panel (see page 43).
2. Early models: the hole is marked out on the
front rail.
3. Remove the rivets with a screwdriver and flatten
with a polygrip.
4. Early models: Drill a 3/16" diameter hole in
the front rail at the marking.
5. Secure the new front rail.
6. Replace the control panel.
Front rail
P/N 8061690