Asko T700 Series Service Manual page 29

REMOVING THE INPUT TERMINAL REMOVING THE INPUT TERMINAL REMOVING THE INPUT TERMINAL
REMOVING THE INPUT TERMINAL REMOVING THE INPUT TERMINAL
B L O C K B L O C K B L O C K B L O C K B L O C K
1. Remove the top cover (see page 23).
2. Remove the grounding screw.
3. Remove all the wiring.
4. Press in the latches with a screwdriver and pull
out the input terminal block.
REPLACING THE INPUT TERMINAL REPLACING THE INPUT TERMINAL
REPLACING THE INPUT TERMINAL REPLACING THE INPUT TERMINAL REPLACING THE INPUT TERMINAL
B L O C K B L O C K B L O C K
B L O C K B L O C K
5. Fit the input terminal block. (The latches must
snap on to the edge of the plate.)
6. Install the wiring in accordance with the
electrical schematic diagram. Make sure the wires
are correctly replaced.
7. Secure the grounding screw.
8. Replace the top cover. Don't forget the two star
washers for the outer screws.
INPUT TERMINAL BLOCK AND RADIO INTERFERENCE FILTER
Input terminal block
P/N 8061660
Grounding screw
P/N 8901097
REMOVING THE RADIO INTERFERENCE REMOVING THE RADIO INTERFERENCE
REMOVING THE RADIO INTERFERENCE REMOVING THE RADIO INTERFERENCE REMOVING THE RADIO INTERFERENCE
FILTER FIL FIL TER TER TER
FIL FIL TER
1. Remove the top cover (see page 23).
2. Disconnect the wiring from the radio
interference filter.
3. Check the filter by taking an ohms reading
between connections 1,3 and 2,4.
4. Unscrew the nut securing the filter.
REPLACING THE RADIO INTERFERENCE REPLACING THE RADIO INTERFERENCE REPLACING THE RADIO INTERFERENCE
REPLACING THE RADIO INTERFERENCE REPLACING THE RADIO INTERFERENCE
FIL FILTER FIL FIL FIL TER TER TER TER
5. Fit the radio interference filter.
6. Install the wiring in accordance with the labels
on the wires. Make sure you connect the wires
to the correct flat pin connectors.
7. Replace the top cover. Don't forget the two star
washers for the outer screws.
Radio Interference filter
P/N 8058558
29