Changing The Guides - Asko T700 Series Service Manual

TOP COVER AND LOWER COVER
REMOVING THE TOP COVER REMOVING THE TOP COVER REMOVING THE TOP COVER
REMOVING THE TOP COVER REMOVING THE TOP COVER
1. Remove the three T20 screws at the rear of the
top cover. (Keep the two star washers.)
2. Tilt the cover and pull it backwards.
Screws
P/N 8900369
Top cover
P/N 8061817-0
REPLACING THE TOP COVER REPLACING THE TOP COVER
REPLACING THE TOP COVER REPLACING THE TOP COVER REPLACING THE TOP COVER
3. Ensure that the sealing strip is positioned along
the edge of the top cover.
4. Push the front edge of the top cover under the
panel and lower the cover.
5. Secure the cover with the three screws at the
rear. Don't forget the two star washers for the
outer screws.
Sealing strip
P/N 8061854

CHANGING THE GUIDES

CHANGING THE GUIDES CHANGING THE GUIDES
CHANGING THE GUIDES CHANGING THE GUIDES
1. Remove the top cover (see this page).
2. Squeeze the latches together and pull or push
the guide upwards.
3. Push the new guide into place.
4. Replace the top cover. Don't forget the two star
washers for the outer screws.
REMOVING THE LOWER COVER REMOVING THE LOWER COVER
REMOVING THE LOWER COVER REMOVING THE LOWER COVER REMOVING THE LOWER COVER
1. Remove the two 20 torx screws (A) at the
bottom of the lower cover.
2. Next, grasp the sides and pull it forward and
down.
Lower cover
P/N 8061850
Screws (A)
P/N 8900327
NOTE:
Fixing clips are available to replace the screws on
the lower cover. For more information, refer to
Appendix A on page 62.
Guide
P/N 8061763
23