Changing Rear Bearing/Felt Strip Seal - Asko T700 Series Service Manual

CHANGING THE REAR BEARING CHANGING THE REAR BEARING CHANGING THE REAR BEARING
CHANGING THE REAR BEARING CHANGING THE REAR BEARING
1. Remove the top cover (see page 23) and the rear
panel (see page 26).
2. Remove the screws and the cable clamp that
secure the inner and outer rear panels.
3. Lift them apart.
4. Change the bearing.
5. Put the inner rear panel and the bearing on the
shaft.
6. Align the outer rear panel and secure the inner
rear panel to it, along with the cable clamp.
Rear Bearing
P/N 8004439
WARNING WARNING WARNING WARNING WARNING
It is important that the wiring bundle runs along
its groove.
7. Remove the special tool.
8. Secure the rear panel to the side panels and
bottom.
9. Install the remaining wiring in accordance with
the electrical schematic diagram and refit the
disconnected cables.
10. Replace the top cover. Don't forget the two star
washers for the outer screws.
11. Tighten the centering nut.
BEARING AND REAR FELT STRIP SEAL
CHANGING THE REAR FEL CHANGING THE REAR FELT STRIP SEAL CHANGING THE REAR FEL
CHANGING THE REAR FEL CHANGING THE REAR FEL
1. Remove the top cover (see page 23) and the rear
panel (see page 26).
2. Lift off the felt strip seal.
3. Thread the new felt strip into place.
4. Using the special tool, tighten the tensioning
band around the felt strip.
5. Fold over the felt strip.
6. Replace the rear panel.
7. Replace the top cover.
Rear felt strip seal
P/N 8052649
Special tool
P/N 7281615
T STRIP SEAL T STRIP SEAL T STRIP SEAL
T STRIP SEAL
27