Asko T700 Series Service Manual page 49

CHANGING THE MICROSWITCH FOR CHANGING THE MICROSWITCH FOR CHANGING THE MICROSWITCH FOR CHANGING THE MICROSWITCH FOR CHANGING THE MICROSWITCH FOR
THE CONDENSED W THE CONDENSED WA A A A A TER PUMP THE CONDENSED W
THE CONDENSED W THE CONDENSED W
1. Remove the rear panel (see page 26).
2. Remove the wiring and the microswitch.
3. Check for power and ohms.
4. Fit the new microswitch.
5. Replace the rear panel.
Microswitch
P/N 8052643
CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL
CHANGING THE FOAM RUBBER SEAL CHANGING THE FOAM RUBBER SEAL
1. Remove the rear panel (see page 26).
2. Change the seal.
3. Replace the rear panel.
Foam rubber seal
P/N 8059711
TER PUMP TER PUMP
TER PUMP TER PUMP
CONDENSER (T720/T780)
CHANGING THE FLOAT T T T T CHANGING THE FLOA CHANGING THE FLOA CHANGING THE FLOA CHANGING THE FLOA
1. Remove the drum (see page 32).
2. Remove the external fan housing (see page 33).
3. Remove the snap fasteners with the aid of a
screwdriver and lift out the condenser assembly.
4. Remove the four screws that secure the
condensed water pump.
5. Remove the seven screws from around the edge.
6. Remove the foam rubber seal.
7. Take apart the two halves of the housing.
8. Change the float.
9. Screw the housing halves together.
NOTE
We recommend changing the foam rubber seal every
time the housing is dismantled.
10. Replace the external fan housing.
11. Replace the drum.
Float
P/N 8053056
Float Pin
P/N 8053098
49