Service manual TD60
Replacing panel
Instructions
1. Unscrew the top cover.
2. First, remove the main push switch.
Carefully press the catches that secure
the panel at the front beam. Release
the catches from the front member by
working the panel outwards.
3. Detach the panel by angling and pulling
it carefully outwards at the lower edge.
Note: Do not damage the wiring!
4. Carefully disconnect the wiring from
the control unit.
11. When installing the panel: First install
all wiring in the relevant locations on the
control card.
Then angle the panel outwards and
place the mounting plates in the relevant
grooves in the front frame. Angle the
panel downwards and secure it with the
catches
12. Screw the top cover into place.
24
Image