Preparing The System; Inserting Batteries Into The Remote Commander - Sony Ipela PCS-XC1 Operating Instructions Manual

Preparing the System

Inserting Batteries into the Remote Commander

CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
When you dispose of the battery, you must obey the law in the relative area or country.
Most of the operations with the unit can be controlled with the supplied
Remote Commander.
1
Remove the battery compartment cover.
2
Insert two size AA (R6) batteries with correct polarities into the battery
compartment.
3
Replace the cover.
Note
Be sure to insert the batteries
damage the insulated film covering the batteries and cause a short circuit.
Battery life
When the batteries are exhausted, the LED indicator does not light if you press
any button and the Remote Commander does not function properly. Replace
both batteries with new ones.
Notes on batteries
To avoid damage from possible battery leakage or corrosion, observe the
following:
E
side first. Inserting them forcibly
e
side first may
Preparing the System
19