Power Management Setup - Quanmax KEEX-2010 User Manual

HDD Power Down
This is selectable only when the Power Management Option field is set to User Define. When the system
enters the HDD Power Down mode according to the power saving time selected, the hard disk drive will be
powered down.
Options - Disable, 1 ... 15 Min
Suspend Mode
Sets the period of time after which the suspend mode activates.
Options - 1 Sec, 5 Sec, 10 Sec, 15 Sec, 30 Sec, 45 Sec, 1 Min, 5 Min, 10 Min, 15 Min, 30 Min, 45 Min, 60 Min,
90 Min. 120 Min
Video Off Option
This field is used to activate the video off feature when the system enters the Suspend mode.
Options - Always On, Suspend -> Off
Video Off Method
This determines the manner in which the monitor is blanked.
Blank Screen: This option only writes blanks to the video buffer.
V/H SYNC+Blank: This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
DPMS: Initial display power management signaling.
MODEM Use IRQ
This determines the IRQ, which can be applied in MODEM use.
Options: 3, 4, 5, 7, 9, 10, 11, NA
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your system.
Delay 4 Sec: Regardless of whether the Power Management function is enabled or disabled,
if the power button is pushed and released in less than 4 sec, the system enters the Suspend
mode. The purpose of this function is to prevent the system from powering off in case you
accidentally "hit" or pushed the power button. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4 seconds will power off the system.
Instant-Off: Pressing and then releasing the power button at once will immediately power off
your system.
KEEX-2010 Series User Guide

Power Management Setup

4-21