Supervisor/User Password Setting; Exit Selection - Quanmax KEEX-2010 User Manual

Supervisor/User Password Setting

You can set either the supervisor or the user password, or both. The differences between them are:
Supervisor: is allowed to enter Setup and change the options.
User: is allowed to enter Setup but not to change the options.
When you select either function, the following message will appear at the center of the screen to assist you
in creating a password.
Type the new password, up to eight characters in length, and press <Enter>. The new password will clear
any previously entered password from CMOS memory. You will be asked to confirm the password. Type
the password again and press <Enter>. You may also press <Esc> to abort the change.
To disable a password, just press <Enter> when you are prompted to enter the password. A message will
confirm that password protection will be disabled. Once the password is disabled, the system will boot and
you can enter Setup freely.
When a password has been enabled, you will be prompted to enter it every time you try to enter Setup.
This prevents an unauthorized person from changing any part of your system configuration. Additionally,
when you have enabled a password, you can also require the BIOS to request the password every time
your system is rebooted. This would prevent unauthorized use of your computer.
You can determine when the password is requested in the BIOS Features Setup Menu and its Security
option (see above). If the Security option is set to "System", a password will be required both at boot and
on entry into Setup. If set to "Setup", a password is required only when trying to enter Setup.

Exit Selection

Save & Exit Setup
Pressing <Enter> on this item asks for confirmation:
Save to CMOS and EXIT (Y/N)? Y
Pressing "Y" stores the selections you made in CMOS - a special section of memory that stays on after you
turn your system off. The next time you boot your computer, the BIOS configures your system according to
the Setup selections stored in CMOS. After saving the values, the system is restarted.
Exit Without Saving
Pressing <Enter> on this item asks for confirmation:
Quit without saving (Y/N)? Y
This allows you to exit Setup without storing any changes in CMOS. The previous selections remain in
effect. This exits the Setup utility and restarts your computer.
4-26 KEEX-2010 Series User Guide
ENTER PASSWORD:
PASSWORD DISABLED.