Table 4-16. Pnp/Pci Configurations; Pnp/Pci Configurations - Quanmax KEEX-2010 User Manual

Industrial 3.5” embedded sbc

Hide thumbs

Table Of Contents

Table of Contents

PnP/PCI Configurations

This section describes the configuration of the PCI bus system. PCI, or Personal Computer Interconnect, is a

system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when

communicating with its own special components. This section covers some very technical items and it is

strongly recommended that only experienced users make any changes to the default settings.

PNP OS Installed

Init Display First

Reset Configuration Data

Resources Controlled By

X IRQ Resources

PCI/VGA Palette Snoop

Assign IRQ For VGA

Assign IRQ For USB

** PCI Express rleative items **

Maximum Payload Size

↑↓→←Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values

PNP OS Installed

Select Yes if you are using a Plug and Play capable operating system.

Select No if you need the BIOS to configure non-Boot devices.

Init Display First

Allows you to choose to first activate the VGA on PCI slot, or the onboard VGA.

Options – PCI Slot, Onboard

Reset Configuration Data:

Normally, you leave this field Disabled. Select "Enabled" to reset the Extended System Configuration Data

(ESCD) when you exit Setup and you have installed a new add-on and the system reconfiguration has

caused such a serious conflict that the operating system cannot boot.

Options - Enabled, Disabled.

KEEX-2010 Series User Guide

Phoenix - AwardBIOS CMOS Setup Utility

PnP/PCI Configurations

[No]

[Onboard]

[Disabled]

[Auto (ESCD)]

Press Enter

[Disabled]

[Enabled]

[4096]

F6: Fail-safe defaults

F7: Optimized Defaults