Overview; Jumpers; Figure 2-1. Jumper Connector - Quanmax KEEX-2010 User Manual

Overview

This chapter provides the definitions and locations of jumpers, connectors, and headers.

Jumpers

The KEEX-2010 Series Embedded Boards have several jumpers which must be properly configured to
ensure correct operation.

Figure 2-1. Jumper Connector

For three-pin jumpers (see figure), the jumper setting is designated "1-2" when the jumper connects pins 1
and 2. The jumper setting is designated "2-3" when pins 2 and 3 are connected and so on. You will see that
one of the lines surrounding a jumper pin is thick, or that the pin is square, which indicates pin 1.
To move a jumper from one position to another, use needle-nose pliers or tweezers to pull the pin cap off the
pins and move it to the desired position.
KEEX-2010 Series User Guide

Overview

2-3