Setting The Scsi Address On An External Device; Figure 6-1 Manually Setting The Scsi Address - Silicon Graphics Octane2 Owner's Manual

Setting the SCSI Address on an External Device

To set the SCSI address, locate a switch, button, dial, or jumpers on the external device,
then manually set the address to the number you chose in step 4 of the previous section.
Although you can connect up to 15 wide SCSI devices to the Octane2 workstation,
Note:
some devices may have SCSI address dials that provide only 9 possible addresses.
If the SCSI device has a button, switch, or dial on the back, follow these steps (if there is
no switch or dial on the device, see the instructions included with the device).
1. Remove the SCSI device from its packaging, then locate the button, switch, or dial.
It may be on the rear or bottom of the device. An example is shown in Figure 6-1.
2. Use a small screwdriver or pencil tip to move the dial or button to the number you
chose in step 4 of the previous section.
Caution: Do not assign number 0. This number is reserved for the System SCSI
controller.
Figure 6-1 Manually Setting the SCSI Address
Installing External SCSI Devices
133