Figure 4-15 Removing The Blank I/O Panel; Figure 4-16 Inserting A Pci Board Into The Pci Module; Installing A Pci Board - Silicon Graphics Octane2 Owner's Manual

Figure 4-15 Removing the Blank I/O Panel
4. Insert the PCI board into the connector in the PCI module, as shown in Figure 4-16.
Push gently but firmly until the PCI board snaps into place.
If the board has an extra-long connector that makes it difficult to insert, skip
Note:
to the next section, "Opening the I/O Door for Extra-Long Connectors" on page 84.
Figure 4-16 Inserting a PCI Board into the PCI Module

Installing a PCI Board

81