Reinstalling The Xio Tri-Module - Silicon Graphics Octane2 Owner's Manual

Chapter 5: Installing and Removing XIO Boards

Reinstalling the XIO Tri-Module

124
Caution: To prevent damage to your workstation, reinstall the XIO Tri-Module with the
VPro graphics I/O panel aligned with the top of the workstation, as shown in
Figure 5-18.
Follow these instructions to reinstall the XIO Tri-Module:
1. Remove the cap from the XIO Tri-Module compression connector.
2. Slide the XIO Tri-Module into the guides on the top and bottom of the workstation.
3. Before you insert the XIO Tri-Module, make sure the sliding handles protrude in a
locked position from the I/O panels, as shown in Figure 5-18.
If the sliding handles are flush with the I/O panels, the XIO Tri-Module will stop
during insertion. Pull out the sliding handles until the sliding portion of the XIO
Tri-Module looks like Figure 5-18.
4. Grasp the immovable handle area with one hand while supporting the XIO
Tri-Module with the other, and slide the module into the chassis.
Use the immovable handle to push the XIO Tri-Module into a locked position (the
I/O panels are nearly flush with the workstation when properly inserted, but there
is a slight variation in the depth of the boards.)
5. Push the sliding handles until the sliding portion of the module is flush with the
workstation.