Setting The Scsi Address On The External Device; Connecting One External Scsi Device; Figure 3-18 Turning Off The Workstation - Silicon Graphics O2+ Hardware Reference Manual

Setting the SCSI Address on the External Device

Connecting One External SCSI Device

007-4486-001
Now that you have chosen a SCSI address, you need to set the address manually on the
device that you will install. Most SCSI devices have a push-button switch or dial. The
switch or dial is usually located on the rear or bottom of the device. You may need a small
screwdriver or pen tip to set the dial or push the buttons. See the following:
• If you will install the first external SCSI device, see "Connecting One External SCSI
Device."
• If you will install additional SCSI devices, see "Connecting More Than One External
SCSI Device."
To connect one external SCSI device, follow these steps:
1. Turn off the workstation (Figure 3-18).
Figure 3-18 Turning Off the Workstation
2. Choose the appropriate cable, as follows:
Connecting External SCSI Devices
93