Port Status and Basic Configuration
QoS Pass-Through Mode
ProCurve Switch 2810-48G(config)# int 1-3 qos priority 1
ProCurve Switch 2810-48G(config)# write mem
ProCurve Switch 2810-48G(config)# show config
Startup configuration:
; J9022A Configuration Editor; Created on release #N.10.XX
hostname "ProCurve Switch 2810-48G"
interface 1
qos priority 1
no lacp
exit
interface 2
qos priority 1
no lacp
exit
interface 3
qos priority 1
no lacp
exit
Figure 10-15. Example of Configuring Non-Default Prioritization on Untagged, Inbound Traffic
Message
< priority-level >: Unable to create.
10-30
Ports 1- 3 are now configured to
assign a priority level of "1" (Low) to
untagged, incoming traffic. (Any
inbound, tagged traffic retains its
priority level while transiting the
switch.)
Messages Related to Prioritization
Troubleshooting Prioritization
Refer to "Prioritization Problems" on page C-10 in the "Troubleshooting"
chapter.
Meaning
The port(s) on which you are trying to configure a qos
priority may belong to a port trunk. Trunked ports cannot be
configured for qos priority.
Ports 1-3 are now
configured to assign a
priority level of "1"
(Low) to untagged,
incoming traffic. (Any
inbound, tagged traffic
retains its priority level
while transiting the
switch.)
Need help?
Do you have a question about the ProCurve 2810 Series and is the answer not in the manual?