Port Identity Examples; Sources For More Information - HP ProCurve 2810 Series Management And Configuration Manual

Getting Started

Sources for More Information

Note
1-4
In some cases, brief command-output sequences appear outside of a
numbered figure. For example:
ProCurve(config)# ip default-gateway 18.28.152.1/24
ProCurve(config)# vlan 1 ip address 18.28.36.152/24
ProCurve(config)# vlan 1 ip igmp

Port Identity Examples

This guide describes software applicable to both chassis-based and stackable
ProCurve switches. Where port identities are needed in an example, this guide
uses the chassis-based port identity system, such as "A1", "B3 - B5", "C7", etc.
However, unless otherwise noted, such examples apply equally to the
stackable switches, which for port identities typically use only numbers, such
as "1", "3-5", "15", etc.
Sources for More Information
For additional information about switch operation and features not covered
in this guide, consult the following sources:
■ For information on which product manual to consult on a given
software feature, refer to "Product Documentation" on page xv.
For the latest version of all ProCurve switch documentation, including
release notes covering recently added features, visit the ProCurve
Networking website at http://www.procurve.com. Click on Technical
support, and then click on Product manuals.
For information on specific parameters in the menu interface, refer
■
to the online help provided in the interface. For example: