Listing Commands And Command Options; Listing Commands Available At Any Privilege Level - HP ProCurve 2810 Series Management And Configuration Manual

Using the Command Line Interface (CLI)
Using the CLI
4-8
For example, if you use the menu interface to configure an IP address of "X"
for VLAN 1 and later use the CLI to configure a different IP address of "Y" for
VLAN 1, then "Y" replaces "X" as the IP address for VLAN 1 in the running­
config file. If you subsequently execute write memory in the CLI, then the
switch also stores "Y" as the IP address for VLAN 1 in the startup-config file.
(For more on the startup-config and running config files, see Chapter 6,
"Switch Memory and Configuration".)

Listing Commands and Command Options

At any privilege level you can:
■ List all of the commands available at that level
■ List the options for a specific command

Listing Commands Available at Any Privilege Level

At a given privilege level you can list and execute the commands that level
offers, plus all of the commands available at preceding levels. For example,
at the Operator level, you can list and execute only the Operator level
commands. However, at the Manager level, you can list and execute the
commands available at both the Operator and Manager levels.
Type "?" To List Available Commands. Typing the
commands you can execute at the current privilege level. For example, typing?
at the Operator level produces this listing:
Figure 4-3. Example of the Operator Level Command Listing
?
symbol lists the