Configuring Lldp Operation; Viewing The Current Configuration - HP ProCurve 2810 Series Management And Configuration Manual

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
12-32
Spanning-Tree Blocking. Spanning tree does not prevent LLDP packet
transmission or receipt on STP-blocked links.
802.1X Blocking. Ports blocked by 802.1X operation do not allow
transmission or receipt of LLDP packets.

Configuring LLDP Operation

In the default configuration, LLDP is enabled and in both transmit and receive
mode on all active ports. The LLDP configuration includes global settings that
apply to all active ports on the switch, and per-port settings that affect only
the operation of the specified ports.
Command
show lldp config
[no] lldp run
lldp refresh-interval
lldp holdtime-multiplier
lldpTxDelay
lldpReinitDelay
lldp enable-notification
lldpnotificationinterval
lldp admin-status < txonly | rxonly | tx_rx | disable >
lldp config < port-list > IpAddrEnable
lldp config < port-list > basicTlvEnable

Viewing the Current Configuration

Displaying the Global LLDP, Port Admin, and SNMP Notification
Status. This command displays the switch's general LLDP configuration
status, including some per-port information affecting advertisement traffic
and trap notifications.
Syntax show lldp config
Displays the LLDP global configuration, LLDP port status, and
SNMP notification status. For information on port admin
status, refer to "Configuring Per-Port Transmit and Receive
Modes" on page 12-39.
Page
12-34
12-35
12-35
12-36
12-36
12-37
12-38
12-39
12-39
12-40
12-41