How To Start A Menu Interface Session - HP ProCurve 2810 Series Management And Configuration Manual

Hide thumbs Also See for ProCurve 2810 Series:
Table of Contents

Advertisement

Using the Menu Interface
Starting and Ending a Menu Session
3-4

How To Start a Menu Interface Session

In its factory default configuration, the switch console starts with the CLI
prompt. To use the menu interface with Manager privileges, go to the Manager
level prompt and enter the
1. Use one of these methods to connect to the switch:
A PC terminal emulator or terminal
Telnet
(You can also use the stack Commander if the switch is a stack member).
2. Do one of the following:
If you are using Telnet, go to step 3.
If you are using a PC terminal emulator or a terminal, press
or more times until a prompt appears.
3.
When the switch screen appears, do one of the following:
If a password has been configured, the password prompt appears.
Password: _
Type the Manager password and press
password gives you manager-level access to the switch. (Entering the
Operator password gives you operator-level access to the switch.
Refer to the chapter on local manager and operator usernames and
passwords in the Access Security Guide for your switch.)
If no password has been configured, the CLI prompt appears. Go to
the next step.
4. When the CLI prompt appears, display the Menu interface by entering the
menu command. For example:
ProCurve# menu
results in:
command.
menu
[Enter]
[Enter]
one
[Enter]
. Entering the Manager

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents