HP ProCurve 2810 Series Management And Configuration Manual page 71

In the VLAN
context, the
first block of
commands in
the "?" listing
show the
commands that
will affect only
vlan-100.
The remaining
commands in
the listing are
Manager,
Operator, and
context
commands.
Figure 4-10. Context-Specific Commands Affecting VLAN Context
VLAN Context . Includes VLAN-specific commands that apply only to the
selected VLAN, plus Manager and Operator commands. The prompt for this
mode includes the VLAN ID of the selected VLAN. For example, if you had
already configured a VLAN with an ID of 100 in the switch:
ProCurve(config)# vlan 100
ProCurve(vlan-100)#
ProCurve(vlan-100)# ?
Using the Command Line Interface (CLI)
Command executed at configura­
tion level to enter VLAN 100
context.
Resulting prompt showing VLAN
100 context.
Lists commands you can use in the
VLAN context, plus Manager, Oper­
ator, and context commands you
can execute at this level.
Using the CLI
4-15