EPSON Stylus PHOTO 895/785EPX
4.2.9 LD Roller removal
1.
Remove the Housing from the printer. (Refer to Section 4.2.1 "Housing
Removal")
2.
Take the Head FFC off from the Head FFC holder located along the LD roller
shaft holder.
Figure 4-26. Taking Head FFC out from the FFC holder
Disassembly and Assembly
Head FFC holder
LD roller shaft holder
3.
Remove two screws (C.B.S 3x6 F/ZN) securing the LD roller holder to the Main
frame.
C.B.S 3x6, F/ZN
LD roller holder reinforcement board
Figure 4-27. Removing two screws securing the LD roller holder
Tightening Torque for screw
• C.B.S 3x6, F/ZN screw for screw securing the LD roller holder: 9 +/- 1 kgf.cm
• C.B.S 3x8, F/ZN screw for screw securing the LD roller holder: 9 +/- 1 kgf.cm
Disassembly
Revision A
C.B.S 3x8, F/ZN
LD roller cover
88