Shaft, Roller, Ld Removal - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

4.2.10.1 SHAFT, ROLLER, LD Removal

1. Remove the ASF Unit. (Refer to Section 4.2.10.)
2. Releasing the hook on Gear, 32, remove the gear from SHAFT,
ROLLER, LD.
HOLDER, SHEET,
PAPER FEED
LEVER, HOPPER,
RELEASE
Figure 4-33. SPUR GEAR, 32 Removal
3. Remove LEVER, HOPPER, RELEASE from the right end of SHAFT,
ROLLER, LD.
4. Remove HOLDER, SHEET, PAPER FEED from the right and left LD
roller units.
5. Move the left LD roller assembly to the middle and then remove the E-
ring from the left end of SHAFT, ROLLER, LD.
DISASSEMBLY AND ASSEMBLY
Hook
SPUR GEAR, 32
Disassembly Procedures
Figure 4-34. BUSHING, FIXING, SHAFT/E-Ring Removal
6. Move SHAFT, ROLLER, LD to the left.
7. Release the fixing tab in WHEEL, DETECTOR, and then remove
WHEEL, DETECTOR from SHAFT, ROLLER, LD.
WHEEL, DETECTOR
Figure 4-35. WHEEL, DETECTOR Removal
Revision A
E-Ring
Fixing Tab
SHAFT, ROLLER, LD
101