Shaft, Roller, Ld Removal - Epson Stylus PHOTO 890 Service Manual

EPSON Stylus Photo 890/1280/1290

4.2.10.1 SHAFT, ROLLER, LD Removal

1. Remove the ASF Unit. (Refer to Section 4.2.10.)
2. Releasing the hook on Gear, 32, remove the gear from SHAFT, ROLLER, LD.
HOLDER, SHEET,
PAPER FEED
LEVER, HOPPER,
RELEASE
Figure 4-33. SPUR GEAR, 32 Removal
3. Remove LEVER, HOPPER, RELEASE from the right end of SHAFT, ROLLER,
LD.
4. Remove HOLDER, SHEET, PAPER FEED from the right and left LD roller units.
5. Move the left LD roller assembly to the middle and then:
Stylus Photo 890: Remove BUSHING, FIXING, LEFT from the left end of
SHAFT, ROLLER, LD
Stylus Photo 1290: Remove the E-ring from the left end of SHAFT, ROLLER,
LD.
DISASSEMBLY AND ASSEMBLY
Hook
SPUR GEAR, 32
Disassembly Procedures
BUSHING, FIXING,
SHAFT, LEFT
Stylus Photo 890
Figure 4-34. BUSHING, FIXING, SHAFT/E-Ring Removal
6. Move SHAFT, ROLLER, LD to the left.
7. Release the fixing tab in WHEEL, DETECTOR, and then remove WHEEL,
DETECTOR from SHAFT, ROLLER, LD.
WHEEL, DETECTOR
Figure 4-35. WHEEL, DETECTOR Removal
Revision C
E-Ring
Stylus Photo 1290
Fixing Tab
SHAFT, ROLLER, LD
101