Upper Housing Assembly Removal - Epson DLQ-3000+ Service Manual

3.2.5 Upper Housing Assembly Removal

Step 1) Remove the knob and the release lever.
Step 2) Open the printer cover assembly.
Step 3) Remove the control panel. (See Section 3.2.3.)
Step 4) Remove the adjust switch. (See Section 3.2.4.)
Step 5) Disconnect the harness (red cable from the printer) from the connector (red cable
from the interlock switch) located under the control panel.
Step 6) Remove 2 screws (CBB, 4X16) securing the upper housing assembly to the lower
housing assembly.
Step 7) Using a driver or equivalent, release 2 hooks (on the right and left sides of the lower
housing assembly, near the front) securing the upper housing assembly to the lower
housing assembly. Then lift up the upper housing assembly and remove it.
R e l e a s e L e v e r
A d j u s t S w i t c h
R e a r C o v e r
A d j u s t S w i t c h H a r n e s s
H o o k
L o w e r H o u s i n g A s s e m b l y
Rev. A
C B B S c r e w ( 4 X 6 )
C B B S c r e w ( 3 X 4 0 )
Figure 3-10. Upper Housing Assembly Removal
Disassembly and Assembly
H o o k
S c r e w D r i v e r
C o n t r o l P a n e l
K n o b
C B B S c r e w ( 3 X 1 2 )
3-11