Power Up Your Gateway; Figure 24-3 Connect To; Figure 24-4 Com Properties - Dynamix DW1-FXS User Manual

Step 4. Configure the COM Port Properties as following: Bits per second: 9600, Flow control:
None, Press [OK] button, and then start to configure Gateway.

24.2 Power Up Your Gateway

At this point, you should have connected the console port, the LAN Port, the WAN port and
the power port to the appropriate devices or lines. Plug the power adapter into a wall outlet. The
Power LED should be on. The [Status LED] will come on after the system tests are complete.
The WAN LED and one of the LAN LED come on immediately after the [Status LED] come on,
if connections have been made to the LAN and WAN ports.
Initial Screen
When you power on your Gateway it performs server internal tests as well as line
initialization.
After the tests, the Gateway asks you to enter the Login, as shown.
....Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
Hardware Type : 4FXS
FXS H.323 VoIP Gateway User Manual

Figure 24-3 Connect To

Figure 24-4 Com Properties

- 75 -