Table of Contents
Advertisement
(COM1, COM2 or other COM port) of your workstation. You can use an extension RS-232 cable
if the enclosed one is too short. After the initial setup, you can modify the configuration remotely
through telnet connections.
Step 2.
Connect the VoIP Gateway to the WAN port
Connect the WAN port (silver) on the VoIP Gateway to the Ethernet port on the cable
modem using the cable that came with your cable modem. The Ethernet port on the cable modem
is sometimes labeled "PC" or "Workstation".
Step 3.
Connecting the PC to the LAN
If you have more than one PC, you must use an external hub. Connect the 10/100M LAN
Port (gold) on the VoIP Gateway to a port on the hub using a straight through Ethernet cable. If
you only have one PC, you can connect the VoIP Gateway to the PC directly without a hub. For a
single PC, connect the 10/100M LAN port on the VoIP Gateway to the Network Adapter on the
PC using a crossover cable (red tag).
Step 4.
Connecting the Power Adapter to your VoIP Gateway
Connect the power adapter to the port labeled POWER on the rear panel VoIP Gateway.
Caution: To prevent damage to the VoIP Gateway, first make sure you have the correct
AC power adapter. Please see the Appendices for AC power adapter specifications for
your region.
Step 5.
Grounding the VoIP Gateway
If you want to ground the VoIP Gateway then connect a grounded wire to the F.G. (Frame
Ground) of the VoIP Gateway.
1.7
Additional Installation Requirements
In addition to the contents of your package, there are other hardware and software
requirements you need before you can install and use your VoIP Gateway. These requirements
include:
1.
A computer with an Ethernet NIC (Network Interface Card) installed.
2.
A computer equipped with communications software configured to the following
parameters:
VT100 terminal emulation.
9600 Baud.
No parity, 8 Data bits, 1 stop bit, Flow Control set to None.
3.
Use Internet Explorer 5.5 and later or Netscape Navigator 6 and later versions.
4.
Analog telephone set
5.
Software tools: Gatekeeper (optional)
After the VoIP Gateway is properly set up, you can make future changes to the
configuration through telnet connections
1.8
Setting Up the TCP/IP Protocol
If you are not sure whether the TCP/IP Protocol has been installed, follow these setups to
check, and if necessary, install TCP/IP onto your PCs.
FXS H.323 VoIP Gateway User Manual
- 9 -
Advertisement
Table of Contents
