Figure 24-8 Quit Commend; Figure 24-9 Debug Commend List - Dynamix DW1-FXS User Manual

login: root
Welcome to Terminal Configuration Mode
Please enter your configuration item
usr/config$
Note:
It is recommended that type the [quit] command before you leave the console. If so,
Gateway will ask password again when next user connects to console port.
24.7.2 [debug]
Open debug message will show up specific information while Gateway is in operation.
After executing the debug command, it should execute command [debug –open] as well.
usr/config$ debug
Debug message information and configuration
Usage:
debug [-add type1 [[type2]..]] | -open | -close | -status
-status Display the enabled debug flags.
-add Add debug flag.
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
Example:
debug -add h323 h323vp
debug -open
usr/config$
Parameter Usages:
-status: Display the enabled debug flags.
-add: Add debug flag.
-- h323: h323 related information
-- vp: voice related information
-delete: Remove specified debug flag.
-open: Start to show debug messages.
FXS H.323 VoIP Gateway User Manual

Figure 24-8 quit commend

Figure 24-9 debug commend list

- 94 -