Figure 24-35 Phone Commend List - Dynamix DW1-FXS User Manual

-rbt ringback tone configuration set.
-bt busy tone configuration set.
-dt dial tone configuration set.
-flash flash configuration set.
Note:
ringing frequency
ringing ring ON/OFF : 0 ~ 8000 (Unit : ms)
ringing level
tone frequency
tone freqLevel
tone Tone ON/OFF : 0 ~ 8000 (Unit : ms)
Example:
phone -print rbt
phone -ring 20 2000 4000 94
phone -rbt 440 480 8 8 2000 4000 2000 4000
phone -bt 620 480 8 8 500 500 1023 1023
phone -dt 440 350 8 8 500 1023 500 1023
phone -flash 100 300
usr/config$
Parameter Usages:
-print: Print current call progress tone configurations (ring: ring tone, rbt: ring back tone, bt: busy
tone, dt: dial tone). This parameter should be accompanied with tone type.
-ring: To set RING tone value. The played tone type, when Gateway is receiving a call.
-rbt: To set RingBackTone value. The played tone type, when Gateway receives a Q.931 Alerting
message. In condition that Gateway is the originate side.
-bt: To set BusyTone value. The played tone type, when destination is busy.
-dt: To set DialTone value. The played tone type, when hook off a phone set of workable
Gateway.
-flash: Set the detective flash range in ms, for example, 300-500 ms.
Note:
For tone simulation, Gateway adopts dual frequencies as traditional telephone does. If users
want to have their own call progress tone, they can change the value of tones. High and Low
frequency/level/cadence can be configured respectively.
FXS H.323 VoIP Gateway User Manual
: 15 ~ 100
: 0 ~ 94 (Unit : V)
: 0 ~ 65535 (Unit : Hz)
: 0 ~ 65535 (Unit : mVrms)

Figure 24-35 phone commend list

(Unit : Hz)
- 119 -