Integral Liner Takeup Unit; Paper Cutter; Media Supply Hub; Paper Sensor - Intermec EasyCoder PM4i User Manual

Chapter —Options

Integral Liner Takeup Unit

The integral liner takeup unit is an optional device for peel-off (self-strip)
operation, which means that the labels are separated from a liner (back-
ing paper) after printing and the liner is wound up on an internal hub.
The unit also includes a guide shaft. Peel-off cannot be combined with an
internal fan-fold guide. Also see Chapter 4, "Media Load, Peel-Off."

Paper Cutter

The paper cutter is designed to cut off continuous paper-based stock
or liner between labels. The cut-off labels, tickets, or tags can be col-
lected on an optional tray. The paper cutter can be controlled using the
instructions CUT, CUT ON, and CUT OFF in Intermec Fingerprint
and the Direct Protocol. Also see Chapter 4, "Media Load, Cut-Off."

Media Supply Hub

The rotating media supply hub is designed to fit media roll cores with an
internal diameter of 38-40 mm (1.5 inch).

Paper Sensor

The paper sensor is fitted inside a plastic cover in the center section
below the media supply hub. It can only be used with a rotating media
supply hub and detects when the remaining media supply has reached a
preset minimum diameter, as specified in the Setup Mode.

Tear-Off Bar

The adjustable tear-off bar is particularly useful when delicate media is
used in peel-off operation.

Media Roll Retainer

The retainer is intended to keep large media rolls in place when using a
rotating media supply hub. It restricts the maximum media width to 100
mm (3.9 inches). Installed by the operator.
Intermec EasyCoder PM4i—User's Guide (Fingerprint version)