Table of Contents
Advertisement
Software
4.7 PC Connection Settings
The GL450 can be connected to a computer via USB or TCP-IP (LAN).
(1) Click the "Connect" button on the main menu to display the Connect window.
Select USB or TCP-IP.
(2) Edit
Several settings need to be made to enable connection to your PC.
No.: Select a number from 1 to 10. When a number is selected, a submenu (settings list)
Name: Be sure to enter a name (any name) for device control.
Note: Input of a name is essential
IP Address: Set the IP address for the GL450 connected (when using the TCP-IP interface).
Port:
USB ID:
Group:
When all the settings have been made, click the "OK" button to complete the setting operation.
(3) Connect, Disconnect/Load Conditions, Save Conditions
Connect: When the "Connect" button is clicked to connect the GL450 to the computer after the
4-14
appears.
CHECKPOINT
The number specified here becomes the device number, and is displayed as such in the application.
Set the port number for the GL450 connected (when using the TCP-IP interface)
Set the ID number for the GL450 connected (when using the USB interface)
When two or more GL450 devices are being used for simultaneous measurement,
register them in the same group. This setting must be made for simultaneous
measurement.
settings have been made, "OK" is displayed to indicate that the connection can be
made. Clicking the "Close" button connects the GL450 to the computer.
CHECKPOINT
"NG" is displayed if the connection conditions are incorrect. Check the condition settings once again.
Advertisement
Table of Contents
