Table of Contents
Advertisement
Trigger
The trigger Start/Stop settings are made here.
Trigger Settings/Level Trigger Settings
Start
• Function: Sets the Data Capture Start condition.
• Alarm Output: Selects the alarm output when the Function is Alarm.
Stop
• Function: Sets the Data Capture Stop condition.
• Alarm Output:
• Date, Time:
• Time:
• Trigger Repeat: Measurement is restarted after the stop trigger is generated.
Off:
No trigger is used. Instead, measurement is initiated by pressing the
START/STOP key.
Level:
The start of measurement is triggered when the trigger condition is satisfied.
Alarm:
The start of measurement is triggered with the alarm condition is satisfied.
Specified Time:
(When Repeat Trigger is Off) Measurement starts (data capture starts) at
the specified date and time. (When Repeat Trigger is On) Measurement
starts (data capture starts) at the specified time.
External: The start of measurement is triggered when a signal is input from an
external trigger terminal.
Off:
No trigger is used. Instead, measurement is stopped by pressing the
START/STOP key.
Level:
Measurement is stopped when the trigger condition is satisfied.
Alarm:
Measurement is stopped when the alarm condition is satisfied.
Specified Time:
(When Repeat Trigger is Off) Measurement stops (data capture stops) at
the specified date and time. (When Repeat Trigger is On) Measurement
stops (data capture stops) at the specified time.
External: Measurement is stopped when a signal is input from an external trigger
terminal.
Time:
Sets the amount of time from the start until the end of measurement. (The
time can be specified in 1- second increments).
Selects the alarm output when the Function is Alarm.
Make these settings if "Specified Time" was selected for Function.
If Off was specified for Repeat Trigger, both Date and Time can be specified,
but if On was specified for Repeat Trigger, only Time can be selected.
Sets the end time when "Function" and "Time" have been set.
Software
4-23
Advertisement
Table of Contents
